草榴社区

草榴社区 10BaseT1-S VIP for your Automotive SoCs

VIP Expert

Nov 27, 2022 / 3 min read

草榴社区 Verification IPs

10BASE-T1S specification is targeted for Automotive industry, developed with an objective to achieve collision free, deterministic transmission on a multi-drop network. Automotive applications require deterministic low-latency communication and do not need high data rates. 10BaseT1S protocol is used for sensor and actuator signaling. It allows the integration of diverse sensors into an automotive-Ethernet system and opens the door for new opportunities in Ethernet communication. The 10Base-T1S is a part of IEEE 802.3cg standard that supports data rates up to 10 Mbps over a single twisted pair for networks up to 25 meters.

 

10BASE-T1S

25m

10 Mbit, half duplex/full duplex

 

It supports point-to-point and multidrop network topologies. The devices on a multidrop network share a common cable using the standard Ethernet carrier-sense, allowing multiple access with collision detection (CSMA/CD) methods and operates on PHY-Level Collision Avoidance (PLCA)

Figure 1: Connecting sensors and actuators onboard autonomous cars using Ethernet Communications

PHY-Level Collision Avoidance (PLCA)

PLCA avoids physical collisions on the media, so that reception is never disrupted. It allows the utilization of the entire bandwidth of 10 Mbps and is used to achieve deterministic performance out of CSMA/CD for multidrop networks. The working principle of PLCA is to dynamically create transmit opportunities so that only one node (each node is assigned with a unique ID) is allowed to transmit at a time whilst the others wait for their opportunities.

Key Features of 10Base-T1S Protocol:

  • Each node has its unique ID
  • Each node shares the 10Mbps bandwidth
  • The 10BaseT1S supports a range of 25m
  • It operates using one of the following two methods:
  • Collision Detection (CSMA/CD)
  • PHY-Level Collision Avoidance (PLCA)
Multidrop shared network

Figure 2: A graphic representation of the Nodes on a 10BaseT1S Multidrop Shared Network

草榴社区 Ethernet VIP for 10BbaseT1S:

The 草榴社区 VIP for Ethernet is a suite of advanced verification components and data objects based on System Verilog – UVM compliant technology that can run in every major simulation environment. We are working closely with standard bodies and market makers to bring high quality VIPs, first to the market.

10base serial interface

Key Features of 草榴社区 Ethernet VIP for 10BbaseT1S :

  • Compliance with IEEE 802.3cg standard
  • Test scenarios for 10BASE-T1S interface
  • Used internally to verify Silicon-proven 草榴社区 Ips
  • High performance Native-UVM architecture
  • Comprehensive HTML documentation and expert assistance

草榴社区 VIP for Ethernet is natively integrated with the 草榴社区 Verdi? Protocol Analyzer debug solution as well as 草榴社区 Verdi? Performance Analyzer. 草榴社区 VIP can switch speed configurations dynamically at run time and includes an extensive and customizable set of frame generation and error injection capabilities.

Running system-level payload on SoCs requires a faster hardware-based pre-silicon solution. 草榴社区 transactors, memory models, hybrid and virtual solutions based on 草榴社区 IP enable various verification and validation use-cases on the industry’s fastest verification hardware, 草榴社区 ZeBu? emulation and 草榴社区 HAPS? prototyping systems.

For more information on 草榴社区 Ethernet VIP and Test Suite offerings, please visit http://synopsys.com/vip

Continue Reading