草榴社区 Cloud
Cloud native EDA tools & pre-optimized hardware platforms
Request a Free Trial →
Efficient 3D Printing of N95 Face Mask Filters
Posted on 14 November 2021 by Thomas Spirka
N95 masks have been much in demand during the COVID-19 pandemic, due to being breathable and highly effective at protecting the public, while also reducing environmental waste by being reusable. 3D printed N95 mask filters are also antimicrobial or sterilizable and suitable for flexible design. However, these filters have a slow production rate, something that is being tackled through a workflow involving binder-jet 3D printing, micro-CT scanning, 3D image processing, and CFD simulation. Researchers at the University of Pittsburgh, ExOne, Ansys, and 草榴社区 have worked on developing an efficient digital prototyping process to save time and resources when manufacturing 3D-printed copper and stainless-steel mask filters.
Example of a N95 mask with a filter valve.
Optimizing 3D Printed Filters
Different approaches came together to create the filter workflow:
- Different filter samples were created by using binder-jet printing and sintering, and experimental data acquired
- The samples were scanned on a 12972 uCT machine
- 草榴社区 Simpleware software was used to import image data for segmentation of the porous structure, and for generation of simulation-ready CFD meshes
- Ansys FLUENT? was used to analyze the behavior of N95 masks in normal operation, including porous resistance, with simulations run on Simpleware meshes refined for different conditions to predict which metal powder/sintering combinations met acceptable filtration standards
- Results showed improved filtration efficiency for 5 ?m particles against 1 ?m particles, and how studying high and low flow regions helps provide insights into mask design to improve performance
CFD mesh created in Simpleware software (left), and particle flow simulation in Ansys FLUENT: 1 ?m particles (58% efficiency) (middle) and 5 ?m particles (97% efficiency) (right).
Future Impact
Given the continued demand for N95 face masks and efficient manufacturing of filters, this combination of binder-jet 3D printing and iterative optimization of printing and post-processing parameters shows promise for increasing the reusability of sterilizable metal N95 filters. In addition, design optimization through digital prototyping only takes about four days on average, compared to approximately 21 days with physical methods, and also reduces material waste.
We were excited to take part in this project, especially given the ways this method can be adapted to study other characteristics and improve our understanding of pore behavior, with the benefit of mitigating against large-scale disposal of single-use PPE.
Learn More
Read the full article published in the February/March 2021 issue of Advanced Materials & Processes (AM&P) magazine.
Any Questions?
If you would like to know more, please contact us. Our technical specialists will be happy to show you the capabilities of Simpleware software.